Lcd power supply tester manual

Manual: 1. Plug-in 24pin and plug-in (P4 / P6 or P8) connector into the tester before turn on power. - 20pin ATX PSU: use P4 connector. - 24pin ATX PSU: use P6 connector. - EPS PSU: use P8 connector. 2. Turn on your power supply 3. LCD show each voltage and P.G value on the screen automatic and you can hear 2 beep sounds. 4. 2. Your ATX power supply must not be powered when connecting and disconnecting any of the connectors. 1. Once all power connections have been made, switch on the power. After switching on, you will hear two short beeps and the LCD display will show the PG (Power Good) values. The value for PG must be within a to ms tolerance level. 2. Find the cheap Lcd Power Supply Tester Manual, Find the best Lcd Power Supply Tester Manual deals, Sourcing the right Lcd Power Supply Tester Manual supplier can be time-consuming and difficult. Buying Request Hub makes it simple, with just a few steps: post a Buying Request and when it’s approved, suppliers on our site can quote.

Digital Meter Battery Tester LCD Green Backlight Indicator Battery Capacity Monitor Panel Meter for 12V lead-acid battery etc. This is a DC-DC Power Supply Converter Buck Module, voltage range V to 12V, output power 36W, conversion efficiency more than 90%, to hair the ca. This 20+4 pin PSU Power supply tester with LCD digital readout is a powerful tool for testing your PC's power supply. This tester is compatible with ATX, BTX, and ITX motherboard configurations and will help you avoid expensive damage to your computer. This unit is capable of testing multiple connectors: both and pin power supplies. Product Info. Dr. Power II is a fully automated power supply tester that enables users to easily and quickly determine if a power supply is defective or not. Cutting overall troubleshooting time considerably. Oversized easy-to-read LCD display and audible alarm helps user determine the exact cause of the failure, if there is one.

Purchased this LCD power supply tester to help speed up troubleshooting both at home, and out in the field. Rather than swapping out power supplys or try and. Using the middle connector group along the left side of the testers to test the 6Pin PCI-E (video card) power connectors will give you a +12V2 rating on the LCD tester and a lit up +12V LED on the left side of the standard tester. SATA Power. The SATA power connector is located along the top edge of both testers. When you test this connector you should see all three LEDs along the left side of both units light up; these represent +12V, +V +5V tests. The tester did not beep and/or the. Manual: 1. Plug-in 24pin and plug-in (P4 / P6 or P8) connector into the tester before turn on power. - 20pin ATX PSU: use P4 connector. - 24pin ATX PSU: use P6 connector. - EPS PSU: use P8 connector. 2. Turn on your power supply 3. LCD show each voltage and P.G value on the screen automatic and you can hear 2 beep sounds. 4.