Ktd-83 manual

KTD Installation 2 A / June The KTD Data Signal Distributor is designed for use when it is necessary to split and/or amplify the RS control signal in a Digiplex system. Sixteen amplified outputs are provided. KTD INSTALLATION 1) To mount the KTD chassis use the mounting slots in the side flanges (Figure 1). User Manual 4 Mounting the KTDR The KTDR is designed to fit into a standard EIA inch rack and uses one unit ( in.) of rack space. Mount the unit using the four holes in its front panel and hardware provided from the rack manufacturer. Wiring connections The KTD comes with a 6 ft. ( m) cable that attaches to a modular phone. The KTD is a data signal distributor that is designed for use in a Digiplex(tm) system. It is used when an RS data signal must be dispersed along separate lines of two-conductor, twisted-pair cable. One signal input can be distributed among up to 16 www.doorway.ru: Interlogix.

KTD Installation 2 A / June The KTD Data Signal Distributor is designed for use when it is necessary to split and/or amplify the RS control signal in a Digiplex system. Sixteen amplified outputs are provided. KTD INSTALLATION 1) To mount the KTD chassis use the mounting slots in the side flanges (Figure 1). KTD Introduction KTD/ User Manual 6 B / March Keypad Video switcher KTD PTZ receivers KTD master KTD inputs (0 - ) KTD slave KTD inputs ( - ) Figure 2. System placement of two KTDs INSTALLATION CAUTION: Complete all instruction steps before supplying power to the unit. KTDE Public User Manual Date: Page 7 of 90 1. Introduction This manual describes the KT/Flex, KT/ATXP and KT/ATXE boards made by KONTRON Technology A/S. The boards will also be denoted KT family if no differentiation is required.

4 TruVision DVR 12HD User Manual UPnP settings 83 Network status 83 Appendix E KTD keypad NUMBER J. Incorporating Change 2, Effective October 2, as implemented by DoD Manual (Reference (j)), as it applies to the DoD. KTD Installation 2 A / June The KTD Data Signal Distributor is designed for use when it is necessary to split and/or amplify the RS control signal in a Digiplex system. Sixteen amplified outputs are provided. KTD INSTALLATION 1) To mount the KTD chassis use the mounting slots in the side flanges (Figure 1).